Maintenance / Locks

All products must be installed in accordance with accepted good trade practice (and in accordance with supplied instructions where applicable), and maintained in accordance with these procedures or else the warranty shall be void.

Spray application of a suitable lubricant such as CRC Marine 66®, Innox® or WD40® to the sliding pin inside the bolt and to the lock cylinder is recommended. A tube attached to the nozzle will help to concentrate the spray where you want it to go. There are access holes or slots on all dropbolt products so that this can be done without removing the locks from the doors.

Visit our folding maintenance page for information on maintaining other Centor hardware.